by Jacob Davis | Updated: 05/18/2016 | Comments: 2
When was the last time you checked the air pressure on your automobile’s spare tire? What if you were driving along, got a flat tire, and discovered that your spare tire was flat as well? We don’t often think about our spare tire until we need it, and the same may be true for our data logger’s spare battery. Your Campbell Scientific data logger has a spare battery to protect your data. This backup battery should be periodically checked so you don’t end up stranded in the field without your data.
Since the release of the CR10X, Campbell Scientific data loggers have included an internal lithium backup battery. When the data logger is disconnected from 12 volts main power, the lithium battery maintains the data logger clock and data. When the data logger is reconnected to 12 volts, it seamlessly begins logging data again.
Note: Data loggers such as the CR300, which use flash memory for data storage, do not require a lithium battery for data protection. A lithium battery, however, is still present for maintaining the clock time.
The lithium battery voltage is measured by the data logger once per day, and the value is held in the Status table. The CR300, CR310, and CR200X-series dataloggers are exceptions, as they do not measure this voltage.
Recommended for You: Review the "Connect Window Tutorial."
Typically, the voltage is extremely stable if the data logger is powered from another source and its temperature is stable. A new internal battery supplies approximately 3.6 Vdc, and it should be replaced when its reading is at or below 2.7 Vdc.
When the voltage is below 2.7 volts and the main power supply is removed, there is a risk that you could lose data, the program, and the clock setting. When the lithium battery voltage is below approximately 2 volts, your data logger operation may be affected—even with the main power supply connected. Regardless of the reliability of the main power supply, depleted lithium batteries should be replaced.
Under ideal conditions, the internal battery in a CR1000 or CR6 datalogger typically lasts three years. Conditions such as the RAM being full or temperature extremes can significantly shorten this time.
Tip: You may be able to lengthen the battery life expectancy past five years by using a continuous connection to a main power supply.
The following are some tips to help ensure that you aren’t stranded without your data:
Internal lithium batteries are user replaceable. You can find the instructions in the manual for the specific data logger.
Below are some links to help you quickly find which battery you need:
|Data Logger||Battery Needed|
pn 30028 (3.6 Vdc, 2.4 Ah, AA size cell)
pn 13519 (3.6 Vdc, 1.2 Ah, ½ AA size cell)
pn 15598 (3 V coin cell CR2025)
pn 8025 (3 V coin cell 24 mm CR2430)
pn 13497 (3.6 V 1.65 Ah 2/3 AA size cell)
These batteries are standard sizes, and you may be able to purchase one locally. If you choose to purchase your battery from a third-party vendor, be sure to select a high-quality battery for better performance.
If you have any lingering questions about internal batteries, feel free to post a comment below. I checked the lithium battery voltage on my data loggers. Now, I need to go check the air pressure on my spare tire.
zando | 03/27/2023 at 11:23 AM
I'd like to know if exist some rows of code to collect the Lithium Battery voltage in a table, more or less as is possible to do with the logger battery of my CR1000 (in this last case it is really easy, I simply use a dedicated instruction)
Thank you for your attention,
JDavis | 03/27/2023 at 02:59 PM
You can read the value from the status table into a variable. Then you can save that in a table. The value changes slowly, so no need to save the value often.
LithiumVoltage = Status.LithiumBattery
Please log in or register to comment.