FAQs Frequently Asked Questions About our Products and Solutions

How is the baud rate set using PC400?

When using PC400 to connect to a data logger on an RS-232 port, the baud rate must be matched. This is done through the PC400 data logger settings.

This was helpful

FAQs Home

Similar FAQs

How much does a typical system cost?
How many sensors can a datalogger measure?
If the message “Clock check started” is followed by the message “Clock check failed,” what does this mean?
What are dataloggers?
What is the default TCP/IP port that LoggerNet uses to communicate with PakBus data loggers?
Is LoggerNet software needed to download the data from a data logger remotely?
Can PC400 operate on a 64-bit system?