FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1843 total: showing 961-980)

If a CR200X-series datalogger has not been used in a while and the internal battery is low, will the battery recharge if the data logger is connected to a power supply? Or does the battery need to be replaced?
Instead of saving the data of a CR200X-series datalogger to one large file, how can it be saved in daily, hourly, or half-hourly files?
How do the AM25T and the AM16/32B compare with regard to programming?
How do the AM25T and the AM16/32B compare with regard to flexibility?
How do the AM25T and the AM16/32B compare with regard to their relays?
How do the AM25T and the AM16/32B compare with regard to relay wear and tear?
How do the AM25T and the AM16/32B compare with regard to low-level mV signals?
How do the AM25T and the AM16/32B compare with regard to resistive bridge measurements?
How do the AM25T and the AM16/32B compare with regard to thermocouple measurements?
Does the CS210 need to be regularly replaced?
Does the CS210 require any regular maintenance?
What relative humidity (RH) reading from a CS210 would indicate that it is time to replace the desiccant packs in the enclosure?
What might cause the CS210 to report negative data?
Can the CS210 be connected to a multiplexer?
If the top section of a UT30 gets damaged, can just that section be replaced?
Can the anchor for the UT30 be set alone—without using the bottom 10 ft piece as a guide?
If the paper bag with the UT30 hardware gets lost, how can the hardware pieces be replaced?
Do Campbell Scientific dataloggers directly support the LonWorks communications protocol?
Do Campbell Scientific dataloggers directly support the Profibus communications protocol?
Do Campbell Scientific dataloggers directly support the BACnet communications protocol?

Previous Next