FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1843 total: showing 521-540)

Does the 18529 Morningstar Regulator draw power from the battery during the nighttime?
Is it possible to purchase replacement sensor cables and bearings for the 014A-L? If so, can they be replaced by the user?
Does the 18529 Morningstar Regulator have the Low Voltage Disconnect feature?
What would cause an HS2 to display a DISK FULL error?
Is a 3WHB10K needed to connect five three-wire temperature probes to an AM16/32B
Can eight PT100 sensors be connected to a CR1000 using a 3WHB10K?
Can three-wire PT100 sensors only be used with three-wire half-bridge modules, or can they also be used with four-wire half-bridge modules?
If there is no manual for the 4WHB10K, where is there information about four-wire half-bridge measurements?
Is there a guideline for calibration or calibration verification of the CS547A- probes?
Can the CS547A be cleaned out with a brush?
For the CS547A, what is the purpose of the ionization correction code?
What is a possible installation option for a CS547A in a very flashy stream with high peak runoffs followed by a base flow of 1 to 2 cubic feet per second?
What is the communications interface with the CS547A?
With a CS547A, how can electrical conductivity measurements be corrected for temperature spikes?
What is the maximum number of CS547A probes that can be connected to an A547 interface?
Can multiple CS547A probes be wired to one data logger if there is one A547 interface for each probe?
Can CS547A probes get accurate readings when they are in hyporheic wells where the water level does not change quickly?
What are the units of conductivity output by the CS547A?
Does the CS547A need to remain submerged for long-term accuracy? For example, can it be used in an ephemeral stream?
Can the CS547A be used in saltwater?

Previous Next