All FAQs (1821 total: showing 1721-1740)
- I am trying to set up a CC640 with a CR10x (not the 2M variety) to send images via a freewave radio. I'm wondering if I need loggernet 3 (I have 2) or if I just need the lvcmd.exe file to view these pics through the logger?
- What is the power consumption (mA) of the 05103, 05305, and 05106 anemometers?
- The measurement instructions will likely remain the same but in addition to the multiplier and offset, the type of pulse may change for the wind speed and the excitation voltage may change for the wind direction. The manual easily explains how the logger needs to be programmed.
- If I replace an existing wind set with the wind monitor, will I have to change more than the multiplier and offset in the datalogger program?
- What is the power consumption (mA) of the 05103, 05305, 05108, and 05108-45 anemometers?
- What is the procedure for orienting a WindSonic-L to the cardinal directions, so that the wind direction readings are correct?
- Can I install the 21X Micrologger to capture soil water?
- Can the CR5000 store data with a rate of 1000 Hz?
- When I dial up to the unit I can see the barometric pressure data in real time. When I attempt to collect data from the unit via dial up or even via storage module, the barometric data are all 0's.
- I am looking for information on the 21X datalogger. Removal of the expansion memory module to be specific . I was trained on the CR10X in Edm, but have no info on the 21X.
- Is the 03101 capable of delivering a 0 to 5 Vdc square wave output for the wind speed?
- Do heater resistance values of 37 to 48 ohm indicate a problem with the 229, or are those values within the normal range?
- Is there a limit to how much memory the CR5000 can access/use through the PCMCIA interface?
- Is it possible to transfer data from PC400 directly to a database such as Oracle (possibly through ODBC on Windows)?
- What might cause the 014A-L to miss data, provide readings of 0 constant wind speed, and show various readings of gust speed?
- How do you change the bearings of this sensor?
- Is the CC640 a real-time camera?
- I am trying to communicate with my new CC640 with a WinXP Pro SP2 notebook. I installed the CSI Device Config Utility (v1.3 from the included cd) and did the Power On - Setup on the camera, but I get "The Device version number, 1, is not defined for device, 11." I tried downloading the newest Device Config Utility (1.4) but it didn't have the CC640 listed. How do I communicate?
- Would the SM4M replace an SM192 storage module or could I still get replacement battery for my SM192?
- How many data lines can a SM192 and a SM4M store using a simple program?
Previous
Next