FAQs Frequently Asked Questions About our Products and Solutions

What is needed to connect a sensor that is compatible with wireless sensor interfaces to a CR800, CR1000, or CR3000 in a wireless network?

To incorporate a sensor that is compatible with wireless sensor interfaces into a wireless network, a CWS900-series wireless sensor interface is needed, as well as an A205 CWS-to-PC interface to configure it.

This was helpful

FAQs Home

Similar FAQs

The WindSonic has the average 1 Hz output of 40 Hz block measurements. What does the 40 Hz block measurement mean?
Which relay devices are compatible with the CR800 and the CR850?
How can LoggerNet be upgraded to LoggerNet Admin?
Using Short Cut, how can the average wind direction be calculated?
Can the CR800, CR850, CR1000, or CR3000 upload to an FTP site on scheduled intervals?
If the cable attached to a sensor is too short, can more cable be spliced to the existing cable to make it longer?
To communicate with a CR1000 or CR3000 by TCP/IP using an NL120 or NL240, is it necessary for the data logger to have a fixed IP address?