FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1843 total: showing 361-380)

Using an SW12V, can the 12 V power lead be run to a source other than the data logger 12 V?
What are the voltage and current requirements for toggling the switch of an SW12V?
When should the desiccant inside an enclosure be replaced?
What factors affect the amount of desiccant needed in an enclosure?
If LoggerNet is running on a PC, does that mean that LoggerNetData’s DataFiler can’t be used to access the cache for that instance of LoggerNet?
Why don’t mixed-array data logger tables show up in the Data Filer table selection window?
Where can the MAC (physical) address of an NL100 be found?
What might cause Baler to display “failed to create the file…” or an access permission error when starting up?
What can be done if a new table is not being baled by Baler?
With Baler, how can a user start fresh with a new configuration settings file?
Can Baler be used to push data from a Windows server to a Unix server?
What is Baler?
How can RTMC Run-Time be made to run faster?
Is the one copy of RTMC Run-Time that is included with the purchase of LoggerNet only for use on the same system as LoggerNet, or can it be installed on a different system?
What is the difference between the microSD cards that Campbell Scientific sells and the cards that are commonly used in the consumer electronics at home?
Can the CS11-L activate a small relay?
Can the CS11-L be used to measure amperage from a battery?
Can the CS11-L be used in a three-phase power situation?
How can the CS11-L be used on a data logger other than a CR200(X)?
Can an ST350 be used in instrumental pile load tests with cast-in-situ (bored) concrete piles?

Previous Next