I use the state of the cell modem to determine when to send a call-back request from a datalogger to LoggerNet after the cell modem has been powered up. On the CR300 connected via RS-232 cable "Status.CellState" is used to get the state which goes from "Dialed." to "Network ready.". On the CR800 connected via CS I/O cable I issue the "show state" command via SerialOut which ends with the state of "Dialed.". Is there a reason that the CELL210 goes from "Dialed." to "Network ready." using the CR300 but ends with "Dialed." for the state when using the CR800?