Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR1000X SW-12 have pull-up or pull-down resistor?


chalit Oct 18, 2020 07:51 PM

Hi,

I power the tilt sensor by using SW-12 of CR1000X,

set reading every 30min and warm up the sensor 3min prior to measurement.

After continous reading about 2 months, some of these tilt sensor begin to failure..

So, the tilt manufacture asking about "SW-12 have pull-up or pull-down resistor?" ..

if it have, how it damage our sensors?

Regard,

Log in or register to post/reply in the forum.