FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1843 total: showing 701-720)

Is there an option to allow the collection of the ET107 measurements either via a connection to a laptop or the use of a USB CompactFlash memory unit?
What methods of communication are possible with the CR1000M included with the ET107?
If an ET107 station is already set up, can a barometric pressure sensor be added?
Can 24 Vac work with an ET107, or does it have to be 16 Vac?
What is the weight and size of the ET107 if it is packed completely?
Can the individual measurement parameter data be retrieved separately from the ET107, in addition to the automatically calculated ETo?
What is needed to display data from the T107 or ET107 online?
Is the ET107 compatible with Calsense controllers?
Using an ET107, how can evapotranspiration be calculated based on the measured parameters?
What is the difference between the ET106 and the ET107?
Can a 10164 Water Sampler Control Cable be used to interface Campbell Scientific data loggers with ISCO water samplers?
What is the maximum solar panel size that can be connected to a PS100?
How long does it take to fully charge the PS100 battery?
Is there a published chart of charging voltage versus temperature for the PS100?
Can the PS100 handle a 55 W solar panel, or should an external regulator be used?
Is there a way to record the average influx of energy into the PS100 battery (that is, from a solar source)?
What are the internal and external battery connections on the PS100 used for?
Can an RV battery be used to replace the battery in the PS100?
Can the PS100 be purchased without the 7 Ah rechargeable battery?
On the PS100, what might cause the “charging voltage present” light to be off?

Previous Next