FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

Can the burst mode be used with a CR5000? If so, what is the maximum sampling rate?

Yes, burst mode can be used. The maximum sampling rate depends on the number of sensors and the integration.

This was helpful

FAQs Home

Similar FAQs

To communicate with a CR1000 or CR3000 by TCP/IP using an NL120 or NL240, is it necessary for the data logger to have a fixed IP address?
If the message “Clock check started” is followed by the message “Clock check failed,” what does this mean?
What's the difference between the CR10X and CR10?
If a device or sensor is not available for selection in the Short Cut program, how can it be added?
How many AM16/32B multiplexers can be connected to a data logger at the same time?
Can the CR6 have simultaneous communications (that is, Ethernet and USB) at the same time between two different computers?
Can one license of LoggerNet Remote be installed on multiple computers in a single network?