How can the CS650 or the CS655 readings be corrected for temperature?

The CS650/CS655 manual gives a temperature correction that works in coarse sand, but it should be used cautiously with other soil types. If a temperature correction is required, it is best to determine a soil-specific temperature correction. 

When correcting for temperature, the following effects contribute to the sensor output:

  • The effect of temperature on the measurement electronics inside the sensor head. This is a relatively small effect compared to other temperature effects.
  • The change in the dielectric permittivity of water with temperature. At 0°C, the permittivity of water is approximately 88, at 20°C it is approximately 80, and at 70°C it is approximately 64. If the sensor is in a soil at any given water content, the changing permittivity of water will cause the period average at 0°C to be higher than it is at 20°C. The same soil will have a lower period average at 70°C than at 20°C. In other words, the sensor will overestimate water content at colder temperatures and underestimate it at warmer temperatures. However, that is only true if electrical conductivity is negligible.
  • The change in water content as bound water is captured and released. In soils with high clay content, some of the water is partially or fully immobilized by electrical charges on the surface of the clay minerals. The amount of bound water is temperature dependent and may have a small effect on the sensor readings.
  • The temperature effect of bulk electrical conductivity (EC) on period average. Bulk electrical conductivity increases with temperature; as it increases, it slows down the period average.

The interaction of these effects may be complicated. For example, with increasing temperature, two things happen at the same time:  the falling permittivity of water is decreasing the period average, and the increasing EC is increasing the period average. The net result as to whether the period average goes up or down depends on how conductive the soil is and the contributions of the other temperature effects.

This was helpful

FAQs Home


Similar FAQs